What the Army waist-to-height ratio works out
This page computes army waist-to-height ratio. The Army waist-to-height ratio applies the formula Waist / height, truncated to three decimals. Army Directive 2026-13 replaced tape-based body-fat estimates with waist-to-height screening.
What each field means
- Waist at navel (inches)
- A number; the example uses 34. Values must fall between 0.01 and 100.
- Height (inches)
- A number; the example uses 70. Values must fall between 0.01 and 100.
A worked example
With the values this page opens on — Waist at navel (inches) 34, Height (inches) 70 — the answer is 0.485. The supporting detail reads: Waist-to-height ratio · Official measurements must follow Army procedures.. Reset restores exactly these numbers.
Reading the result
The result is labelled army waist-to-height ratio. It is recalculated on every keystroke from the unrounded values in the form, and the accompanying graph follows the same numbers.
Assumptions and limits
Army Directive 2026-13 replaced tape-based body-fat estimates with waist-to-height screening. This reports the ratio only; official measurement, confirmation, exemptions, and decisions remain with the Army.
Your privacy
Nothing you type leaves your browser.
Related calculators
Parent-based adult height estimate ↗ · Debt-to-income ratio ↗ · Ratio scaling ↗ · Due date ↗