← All calculators / Units

Unit conversion

Enter units exactly as listed in the details.

01 / Your inputsBrowser-only calculation
Unit conversion
—
How it works

The formula

Target = value × source factor / target factor

Example inputs

Value: 1 · Quantity: Length · From unit: m · To unit: ft

Result: 3.28084 · ft · Supported units: m, km, cm, mm, in, ft, yd, mi

What the Unit conversion works out

Give the Unit conversion the values it asks for and it reports unit conversion, worked out from the formula Target = value × source factor / target factor. Enter units exactly as listed in the details.

What each field means

Value
An amount of money, entered without a currency symbol — the example uses 1.
Quantity
Choose between Length, Mass, Volume, Area, Speed. The worked example below uses Length, and switching it changes which rule set the calculator applies.
From unit
Entered as text rather than a single number — the example uses m. Keep the same separators shown there.
To unit
Entered as text rather than a single number — the example uses ft. Keep the same separators shown there.

A worked example

With the values this page opens on — Value 1, Quantity Length, From unit m, To unit ft — the answer is 3.281. The supporting detail reads: ft · Supported units: m, km, cm, mm, in, ft, yd, mi. Reset restores exactly these numbers.

Reading the result

The headline number is unit conversion. Change any field and the figure, along with the graph beside it, is recomputed from the values you typed — nothing is rounded before the arithmetic runs.

Assumptions and limits

Enter units exactly as listed in the details. Negative values allowed for mathematical conversion. Temperature has a separate affine converter.

Your privacy

Nothing you type leaves your browser.