← All calculators / Home

Concrete volume

Rectangular slab estimate.

01 / Your inputsBrowser-only calculation
Concrete volume
—
How it works

The formula

Cubic metres = length × width × depth/100 × (1+allowance)

Example inputs

Length (m): 5 · Width (m): 3 · Depth (cm): 10 · Extra allowance (%): 10

Result: 1.65 · m³ · Cubic yards: 2.158119

Working out how much concrete a slab needs

Volume is length times width times depth, with the depth converted from centimetres to metres, plus an allowance for waste. A 5 m by 3 m slab at 10 cm deep with a 10% allowance comes to 1.65 m³, or 2.158 cubic yards.

Why the allowance is not optional

The raw volume here is 1.5 m³. The extra 0.15 m³ covers the things that always happen: ground that is not perfectly level, formwork that bows slightly under load, spillage, and the material left in the barrow and the chute. Running out of concrete halfway through a pour is a genuinely bad outcome — a cold joint forms where the first batch has begun to set, and the slab is permanently weaker along that line. Ordering 10% extra costs a few dollars; stopping mid-pour costs the slab.

For uneven or excavated ground, 10% is often not enough. Where the sub-base is rough, 15% to 20% is more realistic, and the only way to know is to check the depth at several points rather than assuming the figure you dug to.

Ready-mix and bags are ordered differently

Ready-mix is sold by volume, usually with a minimum load and a charge for part loads, so rounding up to the next practical quantity is normally cheaper than it looks. Bagged concrete is sold by weight: an 80 lb bag yields about 0.6 cubic feet, roughly 0.017 m³, so this slab would need about 97 bags. At that point mixing by hand stops being sensible — a 1.65 m³ pour is a ready-mix job, and continuous placement matters more than the saving.

What this calculator does not decide

It is a volume estimate for a rectangular slab, and nothing more. It does not tell you the strength grade, the mix, whether you need reinforcement mesh or rebar, how thick the sub-base should be, what the frost depth is where you live, or whether a given slab needs an engineer's sign-off. Those are determined by what the slab carries and by local building rules. A shed base and a driveway with a vehicle on it are not the same problem, and only one of them is safely designed from a volume figure.

Common questions

How do I handle a non-rectangular slab?
Break it into rectangles, run each one, and add the results. For a circle, area is π r², which you can multiply by depth yourself.
What depth should I use?
Typical residential slabs run 10 cm for foot traffic and shed bases, and 15 cm or more where vehicles are involved. Changing the example to 15 cm raises the requirement to 2.475 m³ — half as much again, which is why depth is the input to get right before ordering.
Why does it also show cubic yards?
Because US ready-mix is ordered in cubic yards. One cubic metre is about 1.308 cubic yards.

Your privacy

Nothing you type leaves your browser.

Related calculators

Volume ↗ · Cylinder volume ↗ · Roof area ↗ · Mulch quantity ↗