What an appliance actually costs to run
Electricity is billed by the kilowatt-hour, and the arithmetic is watts divided by a thousand, times hours, times price. A 1,000 W appliance for 3 hours at $0.20 per kWh costs $0.60. That is the entire calculation, and it is enough to settle most arguments about what is driving a bill.
The results are usually counter-intuitive
A 2,000 W kettle sounds alarming, but it runs for minutes: an hour of total kettle use in a day is $0.40. A 60 W games console or set-top box left on for 8 hours costs just under $0.10 a day — but it runs every day, which is about $35 a year. High wattage for short periods is cheap; low wattage for long periods quietly is not.
This is why the biggest items on a typical bill are the ones that run continuously or move heat: refrigeration, water heating, space heating and air conditioning. Chargers and standby lights, which attract a lot of attention, rarely amount to more than a few dollars a year each.
Where to find the wattage
Check the rating plate on the appliance, the label on the power supply, or the manual. Two cautions: the plate usually shows maximum draw, not typical draw, and anything with a thermostat or a motor cycles on and off. A 2,000 W heater holding a room at temperature might draw full power only a third of the time, so the honest input is effective hours at full power rather than hours switched on. A plug-in energy monitor removes the guesswork for about the cost of what it will save you in a month of arguments.
Getting the price right
Use the all-in rate from your bill, not the headline unit rate. Standing charges, delivery charges and taxes often add a third or more to the advertised figure. Divide your total bill by the kilowatt-hours used and you have the number that makes these estimates true. If you are on a time-of-use tariff, run peak and off-peak rates separately — shifting a dishwasher or a car charger across the boundary is usually worth more than replacing the appliance.
Common questions
- What about appliances rated in amps?
- Multiply amps by volts to get watts. A 5 A device on a 120 V supply is 600 W; on 230 V it is 1,150 W.
- Is standby power worth chasing?
- Modern equipment is capped at around 0.5 W to 2 W on standby, which is a few dollars a year across a household. Older equipment and anything with an external power brick can be considerably worse — measure before you start unplugging things nightly.
- How do I work out a monthly cost?
- Enter the hours used per day, then multiply the result by 30. Running the example figures daily comes to $18 a month.
Your privacy
Nothing you type leaves your browser.
Related calculators
Fuel cost ↗ · College cost projection ↗ · Trip cost split ↗ · Roof area ↗